1984 318i idle speed changes from 1400 rpm to 900 rpm I have a 1984 bmw 381i. When the car warms up the idle changes from 1400 rpm to 900 rpm. The car will idle at 1400 rpm then i drive a little way ...
The RPM of Nissan Altima stays high when drive over 65 MPH. I have this problem too. My car is a 2005 Nissan altima. When I drive over 65 MPH, the RPM will increase along with the speed. At 75 MPH, ...
...90 the RPM IS 2500 but other cars the rpm is 2000 you most likely have an older car or more used car that has more sludge in the engine which makes you need more rpm's to go as fast as a cleaner ...
what are the torque specs for the main caps? Engines & Power (more) Four-Wheel Drive Trims Laredo 4WD TSi 4WD Limited 4WD Orvis 4WD Standard Engine 4.0L 185 hp I6 4.0L 185 hp I6 4.0L 185 hp I6 ...
driving on the road the RPM goes higher wituout speedind I was driving on the highway 50-60 miles/hr all of a sudden thye car started whistleing and the RPM went between 5-6000 . I pulled tghe car at ...
Question about 2008 Avalon
when i shift car from P to R or D the rpm suddenly goes to zero and then suddenly goes to approx 2000 rpm. in running car is ok.no trouble at all only when i put the car in gear from parking to ...
Question about 1993 Prizm
'99 silverado 5.3 engin will not idle runs at 2500 rpm and drops down to 1000 rpm the back up to 2500 rpm ------------------------- '99 silverado 5.3 engin will not idle runs at 2500 rpm ...
Question about 2009 Corolla
Today ..I went to mechanic ..then he make rpm setting ..now my car RPM in morning time 800 rpm without A/C.when i start the A/c then i was 1000 Rpm ..but after running 50 KM..i checked the car .i make
40 psi oil pressure What engine ? 4.3 , 4.8 , 5.3 , or 6.0 L Oil Pressure - Minimum - at Normal Operating Temperature 42 kPa at 1,000 RPM 125 kPa at 2,000 RPM 166 kPa at 4,000 RPM 6 psig at 1,000 RPM ...
2002 Ecotec 2.2 DOHC - No Pulse on Ignition Module I have a crank no start condition. I checked fuel and I'm at 50 PSI. I then proceeded to check spark and I found I have power on the output pin of ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions