Questions & Answers for: carrier weathermaker 1

Carrier Weathermaker gas 8000 will not ignite This gas furnace runs OK some of the time, but will not ignite sometimes unless I switch the thermostat off and on again (2nd thermostat-both problems). ...

Weathermaker SX Carrier 58SX060-cc-1 My weathermaker SX is old I believe 1985 or 1987 the coil keeps freezing up. My husband thawed it out and worked fine for a day. The next day it did the same thing

Carrier Weathermaker 9200 Model 58MXA I have two of these in my house. One of them apparently has a leak, because no cold air comes out of the vents, and the tray around the bottom of the unit has ...

...Carrier Weathermaker SX model 58SX060-CC-1, series 150, 66,000 BTU furnace. The intake/exhaust fan starts when the thermostat tells it to, the pilot lights, but the main flame does not ignite. The ...

Carrier Weathermaker SX model 58SX060-CC Blower runs all the time I have a Carrier Weathermaker SX model 58SX060-CC-1, series 170, 66,000 BTU furnace. The intake/exhaust fan starts when the thermostat

...carrier weathermaker 8000 gas furnace-well insulated 2,000 sq. foot patio home,purchased new,13 years old.have furnace serviced & checked twice yearly.change filter monthly.Heating bill 250-300, ...

...your combustion fan assembly instead. Newer furnaces have a in-shot burner and are nosier than the old style of heater. I haee carrier weathermaker 8000 and th eoutside FAN WILL NOT TURN ON? Thk

...carrier weathermaker 8000? Water leaking on my floor from my ac unit. A co worker suggested I check the drain line for a blockage and empty the condensation pan. Where are they located and how doi ...

(a metal filament that glows hot/bright when electricity flows through it to ignote gas) is bad. My Carrier 8000 uses a LH 33ZS 004 ignitor. Google your model and Carrier ignitor to see what your unit

...carrier weathermaker 38tkb unit 40,000 btus 10.5 seer 3.5 ton - what should start amperage be?? is 132 too high tks as you are running 2.5 or 3 mm wire for the unit , at 132 amps the wire would melt ...