Questions & Answers for: carburetor won idle

...won,t idle You need to pull the cover and track where the trottle cable goes to on the motor. If you have someone open and close the throttle while you're watching you will find the linkage that it ...

...carburetor vent line plugged. 12. Needle and seat stuck closed in the float bowl. 13. Multi carburetors not in sync. For more information about your issue and valuable "FREE" downloads that you will ...

...won't do a thing IDLE SPEED CONTROL NOT WORKING ON CARBURETOR CAUSING ENGINE IDLE TOO LOW. I REMEMBER I HAD OLDSMOBILE WITH CARBURETOR I HAD SAME PROBLEM YOU HAD,MAKE SURE SPARK PLUGS AND WIRES ...

won't idle, too tight and it will pull the throttle cable tight and rev engine. It could also be a carburetor issue if it runs with choke. Either the idle screw isn't adjusted or the pilot jet

...won't idle without choke why doesn't it idle without choke Hi, Anonymous and the usual suspects are: 1. Fuel cap or fuel tank is not venting properly. 2. Fuel filter clogged. 3. Fuel line ...

...carburetor vent line plugged. 12. Needle and seat stuck closed in the float bowl. 13. Multi carburetors not in sync For more information about your issue and valuable "FREE" downloads that you will ...

saw to where it won't cut off... There should be an idle screw on th carburetor labeled H and L for High speed idle and Low speed idle, adjust the screw to where it'll run.... I hope this helps...

Won't idle. Cleaned carburetor & replaced spark plug & tried to adjust carburetor screw. Hard to start without starter fluid, Runs hot quickly, and won't idle. Your float adjustment is

...won't idle down, what do I need to fix check the linkage on the top of the carburetor that controls the butterfly, it may be stuck. lubricate the shaft that runs through the carburetor with the ...

...Carburetor bowl vent line clogged/blocked/pinched. 8. Idle adjusting screw set too low. 9. Air/fuel mixture screw set too lean. 10. Idle port, transfer ports, slow air jet clogged. 11. Slow fuel jet ...