Questions & Answers for: carburetor settings

...sec and then stabilizes. Hello: >>The Cause of this is a Slightly Restricted Passage or Jet in the Carburetor and it Takes a Few Seconds for the Governor the Engine at a Slightly Higher RPM to ...

...out of the muffler.What can I do to start the motor. Hello If you Used Spray Cleaner to Clean the Carburetor, then you Need to Remove the Carburetor and Soak it in Cleaner Overnight. The Float ...

...but dies when moving to 1/2 choke or to run setting. Fuel is new. Hello roda551: This can be a Carburetor Problem or an Exhaust Problem. I Suggest you Check the Exhaust First and then the ...

...plug, carb clean, new air filter, only a year old help? Hello jusapup68: >>Did you Soak the Carburetor when you Cleaned it? >>If No, then the Carburetor can Still be the Problem.

from where. RAW If there is a fuel leak causing this problem it could be from the line going to the carburetor or the float bowl. If no leak is present there, could be flooding or a sticking needle in

...and does the same over and over. Hello roobar2009: >>From your Description it Sounds like a Carburetor Problem, a Bad Fuel Filter or Bad Gas. >>If you have Changed the Filter and the

...carburetor settings and tune it for more air flow ratio from a ecperienced mechanic If your model has earlier then 2010 may the carburetor jets are over sized, when the petrol are coming with ...

...Carburetor Adjustment - Tune-up Settings tekindoor.com > MISC Stihl chainsaw's have three carburetor adjustment screws (LA) Idle Speed screw - This ... When the engine is tested at the factory the ...

...settings Adjustment and Tuning of a Chainsaw Carburetor ' Chainsawr store.chainsawr.com/.../tuning.../1126042-adjustment-and-tuning-of-a-c... Carburetor Adjustment for Chainsaws Carburetor adjustment ...

1977 GS750 Throttle slide height Looked at manual and it says when the carburetor slides are opened wide open it should be .5-1mm above the top of the top of carb. Problem is the bike idles high so my