...to prevent the Carburetor from dry after sitting for a while I suggest letting the car run for 5-10 minutes . I do that with my 78 El Camino SS 350 and after the carb is primed it starts right ...
...carburetor or remove the exhaust, try the simple things below: 1. Air Filter maintenance. Your air filter needs to be reasonably clear. You can clean with water/soap, insure it is dry and lightly oil ...
...carburetor or remove the exhaust, insure that your air filter is reasonably clear. You can clean with water/soap, insure it is dry and lightly oil and replace. Mantis has a very good customer service ...
...2 yrs we change the fuel as soon as it's given gas it shuts off Your going to need to remove the carburetors and clean them.The jets in the carbs are pluged up with dried fuel.Hope this helps you ...
...carburetor, just in front of the right side chrome side plate. I turn off the gas whenever I park the bike. So far that has worked, although I have other (unrelated) problems with this bike. The ...
...SITTING FOR ABOUT 3 YEARS. I HAVE PUT NEW PLUGS AND WIRES ,NEW GAS WILL TURN OVER BUT WONT START Check the fuel pressure at the Carburetor or fuel rail, depending on which you have. Most likely ...
Question about 21" 208cc* Single-Stage Snowblower w/ Electric Start
...carburetor, disassemble and soak over night in carb cleaner. The key is to use non-oxygenated fuel and a fuel stabilizer added to the gas can. Follow the stabilizer instructions for storage. I ...
Question about 21" 208cc* Single-Stage Snowblower w/ Electric Start
clueless chick, so far. The carburetor needs cleaning and possible a few parts in it needs replacing. It is the result from sitting and the fuel drying up in fuel bowl gumming up the entire carburetor
Question about 21" 208cc* Single-Stage Snowblower w/ Electric Start
...dry should not cause a 'no start' condition. It should not cause this type of problem. I suspect the diaphram in the carburetor is getting stiff and brittle. This prevents the fuel being pulled into ...
Question about Gas-Powered Pressure Washer - 4 GPM, 3500 PSI, 414cc
starts with choke on, dies when choke is moved to run. carburetor needs cleaning. lots of youtube videos to show you how. The best way to avoid this happening again is to close the valve in the gas ...
Usually answered in minutes!
843 Questions
243 Questions
163 Questions
186 Questions
140 Questions