Questions & Answers for: Homelite carborator

parts number i need the parts number for the carborator and diaphram gaskets for a homelite ut2000-4a trimmer. You need to know if it is a walbro or a zama carb. to start with. then look closely at ...

...Saw will start will choke out, when choke is pushed in, it stops. Homelite 45CC I have replace all carborator gaskets and mandifold, new fuel lines and filter. When it does idle and you mash throdle ...

ajust carborator which scruew to adjust idal speed which screw toadjust high speed [email protected] h = high speed l=low speed

carboratoe loose carborator loose there's two bolts holding it on, tighten them

...not pop back up this is an indication that there a gas blockage in either the fuel lines or the carborator. try taking fuel lines off of gas tank, which might require you to take off any ...

Trying to adjust carb on hb-180v model #08010B...air adjustment screws on carborator are not marked. There are 2 screws with a spring behind each of them on the side of the carborator. The one on the ...

...an on switch just a kill button. The spark plug is new and the gap is set at 0.025. I rebuilt the carborator and it is getting fuel in the combustion chamber. If you are not getting any spark, ...

generator just stopped, teck.said it could be the carborator. quest. why does it take a month or more to fix. cause there are so many different carb's out there and probably had to order the parts

15084 homelite carborator adjustments. Homelite is a piece, Ive bought them cause they were cheap  and that they are. I have also repaired them. Usually its not carb needing adjusting its a crack

FOR THE FILTER AND THE RETURN LINE TO THE TANK ... ALSO IS THERE A CARB. VENT FOR THE GAS TANK? THE CARBORATOR HAS TWO FUEL LINE TUBES , ON FOR THE FUEL FILTER AND ONE FOR THE FUEL RETURN... I NEED TO