car wont shift into gear I put a remot start on my car and now it wont shift into gear what could this be the install is done roght because i do this for a liveing so i no its not the install did you ...
car wont move out of park my car will start but cant move gear out of park,any suggestions?{automatic} thank you There is an interlock that requires the brake pedal to be depressed in order to shift ...
...car? Are there any better transmissions than the stock automatic that will bolt up to the 5.0 very easy? The transmission slips on occasion and sometimes it hits a spot where it acts like it's gear ...
...car shift normally but if you hit the pedal hard, it will slip from 2nd to 3rd. However the check engine light is not on. but my scanner is not reading so I checked the fuses and its seem to be ok. I ...
...wont shift into drive but only does this after warmed up? it has a three year old trannsmission in it, the fliud and filter are clean. it will start out and drive normal hitting 1-2 gears but then ...
...wont let shift to any other till manually moving shift rods underneath. any suggestions Check the shift rods for binding, also check the hole ends, are the bushings bad? Hope this helps, let me ...
...pot hole - car lost fuel power still will try to turn over but no ignition 1998 Ford Mustang If you hit the pothole hard enough, your fuel cut-off may have actuated. Locate the cut off, (some of them ...
Question about 1995 Mustang
...wont shift from park its hard to move out of park but won't shift out of park won't go in gear from park, i can barely move the gear shifter and when i do put it in reverse or neutrel or ...
...wont shift unless shut car off and put it in the gear and restart car and there is high pitched noise while trying to shift in gears Did you check your fluid level? If this is on a Borg Warner World ...
Question about 2007 Mustang GT
...shift to 3rd it stops. 5.000rpm's high revs and you run into problems with valve bounce ( hitting pistons) ,ring slap, gudgeon pin knock, big end noise and possible main bearing noise . You may also ...
Usually answered in minutes!
706 Questions
694 Questions
653 Questions
589 Questions
617 Questions