Questions & Answers for: car seems running 2 outside

Question about 2006 L300

1 Answer

...car has 3 Oxy sensors 1) 1 0n Cylinders 246 Front - BEFORE Ca Converter - Cost 130,00 2) 1 on Cylinders 135 Back - BEFORE Cat Converter - Cost 57.00 3)1 After Cat Converter The one that appears ...

Ad

Question about 1994 Previa

2 Answers

...seems like i have to take the whole door locking mechanism off so that it will drop down? any easier way? Yes. It is a difficult job, but not impossible. The hardest part is actually removing the ...

Ad

seems to make it worse.when its cold outside it is not as bad as when its hot outside. when i start it it usually runs for a minute or so then begins to tick intermitenly on the number 2 cylinder only

Question about 1998 Mountaineer

2 Answers

...car was put on a machine , the machine showed bank one and two.What does this mean. 1998 mercury mountaineer 6 cylinder 4x4 both oxsigen sensors dont work reigth way,on older cars maby is problem ...

...car ran smooth for one day but soon began to misfire again. Sometimes it runs fine for an hour, running roughly after warming up. Other times, it begins to misfire a soon as the engine is started. I ...

...seems to know the cause of it Well, it could be the coil pack. I assume it has one coil for every one or every two cylinders. Sometimes humidity will cause the coils to arc when they otherwise don't. ...

...seems like after its been driven for @ 20 minutes it starts acting up. If I pull over and shut the truck off and turn it back on the problem goes away for a bit but will usually return after 10 ...

...seems fine at the time, he then started the truck and left the engine to idle a bit but say about 2 to 5 minutes the engine stalled and SES light reappears. He then re-scanned the vehicle and got the ...

...running fine until stored outside and not started for the past 2 years (this is in Montreal and there are winters) . Naturally, the battery is dead, there seem to be some rust in the fuel tank, the ...

Question about 2000 Eclipse

1 Answer

...car to our mechanic who put it on the scan tool and code P0330 came up. He cleared it and the miss went out of the gas system. This problem has happened once before and same scenario it seems to be ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...