Questions & Answers for: Hyundai Elantra car makes whirring noise starting

...Whirring noise, from r/hand side of car, it resembles a frayed fan belt; becomes obvious at cruising speed Sounds like a bearing packing up. Could be a siezing alternator, which would put enough of a ...

makes a 'tinny" whirring sound for a few seconds while it slows down after engine starts and starter is deenergized. Bendix drive? Cure? Bob McSweeney lf its not broken don.t fix it. otherwise replace

...car doesnt start intermittently, then it starts no problem. it is not turning over but there is a barely audible whirring sound. I turn key to off and try to restart it immediately starts up. it is a ...

...whirring sound happens on the right side towards the back of the car. does not impede driving, but worrisome because of the noise. any ideas? if you are sure its right rear of car, jack up car so the ...

Car intermitantly will not start..make a click noise but not a click click noise it was jumped one day...seemed fine ...next morning started...next day would not start...my neighbor jumped it said it ...

...WHIRRING NOISE WHEN TRYING TO TURN OVER IS THIS THE STARTER MOTOR? IF SO WHERE IS IT LOCATED Replace the fuel filter and have the injectors cleaned. sounds silly but ave the battrey checked i had the ...

whirring, is the car trying to start but just dont engage. or does it make no sounds at all. It would also be very useful information for any of us who are here, ready, willing and able to help you As

...whirring" noise instead of the car starting wont start. Starter tries to engage but theres a "whirring" noise instead of the car starting Sounds like starter solenoid is failing to kick in. ...

...noise. What would cause this? Is it expensive to repair? Is it something I could do myself? Appreciate any help - Frustrated Lady sounds like speedometer cable is gone or the gears between the cable ...

car makes the noise for about 10 seconds and completely stops. Any idea? You may need to check the belts on your car's power steering section. Make sure the belts are tight and not worn out. Check for