Questions & Answers for: caps won 39 turn

...won't start. You said it won't crank. Does that mean it won't turn over or it just won't start while cranking? you said you replaced distributor cap, and rotor,i know this will sound ...

... wires, distributor cap, pcv valve, and air filter. Now the car won't start - that is, the engine won't turn over. What could be wrong? Did you mix up the wires? That will keep it from ...

...won't start. The starter engages, engine turns, but won't start. I've replaced the ignition module under the distributor cap, gave it a tune up [ cap, rotor,plugs ]. Checked the spark off ...

...won't start. Either the cap is the wrong one, or it is faulty, take it back to where you bought it and have it replaced for another one. Make sure it is the correct one for your model. When you ...

...won't stay tight then the check engine light comes on.I tighten it (3 turns) then it goes off but loosens again.Is there a gas cap that don't loosen? You will just need to replace the gas ...

...won't pass wi how do i turn the engine soon light off when i put gas in then i turn the gas cap 3 times the light goes off for awhile its a new gas cap i need to have it smog but i'm ...

...won't budge. It's plastic so I don't want to break it. are you sure what you're turning is a bypass cap? KitchenAids don't usually have bypass caps. If it is a bypass cap ...

won't go any further.  Then pull straight up  There are tangs on the bottom of the metal top of cap that must be turned (towards loosening) before they allow the cap to be removed. 

...tv....won't turn on...stand by light won't go off Not making it on or out of standby---first place to look is the power supply for signs of damage or puffed up filter caps

...won't suction on when I try to put gas in. i can't get gas to go in my bmw 323i convertible, help? The gas cap is very hard to get off now and the pump won't suction on when I try ...