580ex not flashing at all after have used it very strongly (many flashes at 1/1 power) the strobe doesn't work anymore. Everything seems to be OK looking all over the LCD, but the strobe doesn't ...
...turn on I was using my 30d with the 580EX,I turned both off . When I turned them back on after about 10 min. the speedlite didn't turn on I replaced the Battery's with new ones still nothin. ...
Question about SPEEDLITE 580EX TTL Flash
Canon 580EX clicks when turned on, cannot push buttons on back I'm having same problem as an earlier poster ''My 580EX clicks when I turn it on... the Wide Angle shield is totally in. Plus it is set ...
canon flash 580exii not working my canon flash 580 exii does not fire the ir beam needed to assist af in low light condition , all setting ok on camera which is canon rebel 450d check Custom Functions
Question about SPEEDLITE 580EX TTL Flash
...580EX TTL Flash: flash is making a constant beating/clicking noise ... Flash is making a constant beating/clicking noise when turned on. Will not zoom.....help? Loosen the two small screws under the ...
...canon 60d and i mounted on the 580ex speedlite and it turns on but it wont fire. help? Hello, Usually if my flash isn't firing I check to see if the flash is mounted into the hotshoe properly. I take ...
580EX dropped flash be careful. examine the flash for physical damages. if it appear to be intact, you could try turning it on and see if you can fire with the test button. remember, this flash is ...
Question about Speedlite 580EX II TTL Flash
...canon 580exii speedlight and 2 270exii, I want to use the 270 as slaves, I don't want the master to flash, followed the intructions in booklet, told me to turn off the master, when I do that, ...
Question about Speedlite 550EX TTL Flash
...Canon EOS-1D X/60D/T4i because this flash is over 20 years old. Unless you would want it to be modified by me. But that can be costly when you can get the 580EX II for less than $425.00 USD. ...
Question about SPEEDLITE 580EX TTL Flash
...580EX clicks when I turn it on... the Wide Angle shield is totally in. Plus it is set on ETTL but the Zoom - - mm and the rectangle box is flashing... it will not respond to any buttons pushed or the ...
Usually answered in minutes!
1,383 Questions
1,133 Questions
959 Questions
944 Questions
808 Questions