...ground signal for crank relay from pcm.so there is no power to my starter unless i bypass to ground from wire that connect to relay check pcm with a scanner to see if crank and cam sensor are
Question about 1999 Grand Cherokee
...cam signal or ASD control from pcm I am working on a 2001 jeep grand cherokee with a 4.7 liter. The engine will not start, I know that the cam position sensor is not showing up on the pcm datta. I ...
...cam sensor. Any time that the signal to the PCM is inconsistent with what the signal should be, this code is set. NOTE: this code can also be set by extended cranking periods. Here is a possible ...
...cam sensor signal problem. There may be no noticeable symptoms other than: * Poor fuel economy (if engine runs) * Possible no start condition Causes: A code P0341 may mean that one or more of the ...
...cam sensor signal problem. There may be no noticeable symptoms other than: Poor fuel economy (if engine runs) Possible no start condition A code P0341 may mean that one or more of the following has ...
cam sensor signal problem. There may be no noticeable symptoms other than: Poor fuel economy (if engine runs) Possible no start condition Causes A code P0341 may mean that one or more of the following
...cam signal at pcm install new crank position sensor ran good for a week then installed new tps sensor ran good a couple days then installed new cam position sensor now code reads no cam signal at pcm ...
...cam position sensor signal produces the the timing signal to the injector and coils, also it is used by the PCM to know if the engine is out of timing like timing belt or chain not synchronized ...
Question about 2004 4Runner
...cam signal to the PCM based on these inputs. The PCM uses the cam signal to synchronize fuel injection. The powertrain control module (PCM) supplies a signal on each of the ignition control (IC) ...
Question about 2004 Alero
...cam signal to the PCM based on these inputs. The PCM uses the cam signal to synchronize fuel injection. Do you have DTC - diagnostic trouble code? DTC P0341 Circuit Description This ignition system ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions