...cam-shaft's. we never had a cam-shaft alignment tool but found a scrap piece of metal that worked perfectly for the cam-shaft alignment. the timing belt is on one side of the engine and on the other ...
cam shaft pulley. Count the teeth. Remove the timing belt from cam shaft pulley only. Move cam shaft pulley in reverse according to the number of teeth you counted. Make sure the crank shaft pulley is
...cam shaft after cylinder #4. meaning #5 & #6 have no compression, but also no oil pressure due to no oil pump drive from cam shaft. 2 out of 3 times the engine was toast. If it truly skipped the ...
Question about 2001 Concorde
...cam shaft! please help! the other day i went to start my car and it wouldnt trun over. after having it towed to my mechanic all signes pointed to the crank and cam shaft. so they were replaced. car ...
...cam shaft crank shaft timing the cam shaft was removed put the timing wrong there is no compression on cylinders 1.2and3 hmmm check cam and crank pulleys for stamped dot and use straight edge to line ...
...cam shaft position sensor? PCM= Powertrain Control Module. It is the brains of the car, it reads the sensor in put from all sensors including the cam shaft position sensor PCM , power control module, ...
Question about 2004 4Runner
...from running Vct cam timing will my motornot run if it is faulty cam shaft and crank shaft position sensors both have to work. sometimes a cam shaft sensor fault can be traced to a broken timing
...cam shaft yes it should have timing marks that make sure your cam shaft and crankshaft are aligned. the keyway on the flywheel ligns the flywheel up with its ignition cycle obviously but yes the cam ...
...timing for the engine . Both the crank shaft and the cam shaft have to spin at the same wright .This is what the crank shaft position sensor and the cam shaft sensor are all about . You need a new ...
Question about 2004 4Runner
...cam shaft position sensor, bank 1 sensor A---correlation === causes --wiring---CKP sensor --CMP sensor ---mechanical fault code p 0011 refers to cam shaft (CMP) intake /left /front bank 1 --timing ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions