Questions & Answers for: cam sensor f250

...fine all day I parked, turned off the truck and went into a store. I came back out and the truck turns over fine but will not start. could be the cam sensor has gone out, there was a recall for ...

...is bad. The truck won't start, if the cps is bad, if I heat up the engine area is there a chance the truck will start? more than likely cam sensor is bad and no it will not start if you heat it ...

...f250 diesel 7.3. while i'm driving the motor will just cut off.but it will start right back up.sometimes the check engine light will come on.but when I restart it ,it will go off.It usually happens ...

no start no rpm during cranking replaced cam sen, no start engine speed is calculated from the crankshaft sensor, not the cam sensor. cam sensor only used to denote no 1 cyl TDC

...Cam sensor where else do I look Larry You should be getting the check engine light on. Take the truck to Autozone or similar business for a free computer scan (they will be happy to sell you any ...

...cam postion sensor located just below the water pump on the left side if your looking at the engine try to start vehicle if equipped with tachometer watch to see if it moves if not its more than ...

...cam sensor on the 7.3. It is located in the front of the engine just above the harmonic balancer just to the right. 10mm Bolt holds it in. Easier to get to from below going up behind radiator. ...

...cam sensor. When it cranks does the tack work? that is another sign of a cam sensor It is on the front of the engine just to the right of the harmonic balancer top side. Replace it with a black one. ...

cam sensor will keep the vehicle from starting, so if its starting then I doubt its a sensor problem unless there is a pinch in the wire, grounding out somewhere. but this will kill the engine as soon

...running about 30 minutes then engine stalls, has 136k miles Ford had a problem with the cam shaft sensor located on passenger side of engine on crank shaft thois will cause the engine to shut