where is the cam shaft sensor located my 2006 f250 diesel just shuts down while driving. you pull over and stop and it starts right back up it is located`on the engine, under the power steering pump
how much shld I be charged for the labor of the cam sensor and knock sensor on a 05 Dodge stratus $250 shouldnt take more than an hour, they are easy to change
no fire replaced coil, distributor,module WELL I GUSS YOU MEAN NO SPARK SO I WOULD CHECK CAM SENSOR OR CRANK SENSOR HOPE THIS HELPS
cam sensor code - replaced it - same results. Checked fuel pump, high pressure oil pump, fuses, computer - all check out ok. Any ideas? Did you check for spark? Ignition coil? Ignition control module.
i was drivin my 2004 F-250 6.0 powerstroke and hit cost on the cruse and it died and want start I would suspect cam sensor.
...the 4.2 eng. getting misfire 4,5,6 cyl.... have replaced coil pack plugs wires cam sensor checked feul injectors stumped at this point what about oxygen sensor does this engine have one for each ...
Question about 2003 300M
...cam sensor and $250 later it still wasn't fixed.The next dealer said it was the crankshaft sensor drove away after the repair and another $250 it stalled a mile down the road.I fought with it for ...
Question about 2006 F-250 Super Duty
...cam position sensor. It starts back up right away and runs for a little while and then shuts down again. The engine light is on because #6 glow plug is bad and showing a code for it. Does it keep ...
camshaft sensor location Looking for location for cam sensor on f-250 2012 6.7 diesel king ranch crew look on the rear of the camshaft bearing area or near the cam drive sproket..
Question about 2006 F-250 Super Duty
Sensor Above / Below Desired Error code for Ford. https://www.engine-light-help.com/ford-check-engine-light.html A Generic C1211 OBD2 error code specifically refers to the camshaft (cam) timing. http:
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions