Questions & Answers for: cam sensor

...cam or sensor Could you explain how it could be a bad cam or cam sensor? Check this out.. The cam sensor wires and the Ignition coil wires CAN interchange.. If you reverse them.. It'll blow the ecm.. ...

cam sensor circut replaced cam sensor still dies could it be the crank sensor? thank you Michael Dale cam sensor is only half of the cam circuit, the other half of the cam circuit is the magnet on the

...cam crank sensor on 2004 Audi A4 The "cam crank" sensor is the "reader" for position and speed of the camshaft. This sensor send informations to Engine Control Unit about camshaft position and speed. ...

...signal at pcm, has 5 volt supply at cam sensor and ground at cam sensor. I thought it would start with the cam sensor unplugged, it would just have a long crank time. crankshaft sensor had same ...

cam sensor error changed sensor turns over but won't start. Had a cam sensor error code a few days ago. Changed cam sensor and still same problem. You may have jumped time,since the cam sensor did not

cam sensor what is cam sensor The Cam sensor is used for fuel control you have cam position sensor one on the exhaust and one for the intake.The use of a cam sensor improves mixture for each ...

...in the diagnostic problem cam sensor change cam and crankshaft sensor and still in the diagnostic problem cam sensor just remove the battery terminals for a while firstly removing negative ...

...cam sensor replacement. Car stalling at lights.Code reader said cam sensor. Changed it but still stalling best to change cam and crank sensor as they both need to work together. if either one goes it ...

...Cam Sensor Fault Daewoo: ETS VALVE STUCK - CLOSED 1 Ford: Cam Sensor Fault Hyundai: Electronic Throttle System #1 Close Malfunction Jaguar: System Too Lean - Banks 1 and 2 (Suspect HO2S) Kia: System ...

...cam sensor unplugged will also continue to run after plugging the cam sensor in but if you shut it off it wont start with the cam sensor plugged in you have to unplug it again to start? Replace .cam ...