Questions & Answers for: Oldsmobile Alero calibrate car radio

...radio or the car wires.... here are the car wires and the radio are below that. I suggest however gettiing a wiring kit..They are around 8 dollars and well worth the money. It makes is so easy to ...

...RADIO your car is setup with an anti-thief system. You need the radio code that is inside your radio. Check your owner manual for the 4 digit number. If not in there then you need to take it into the ...

car started long enough for me to move it from the side of the road into my driveway. I tried the 10 minute trick again later and it started for about 60 seconds and died out and all the gauges on the

...IF YOU CHANGE RADIO.BY IT BEING PROGRAM TO PCM.YOU PROBABLY GOING TO HAVE STARTING PROBLEMS.THE THEFT MODE KICK IN.PCM WILL NOT RECOGNIZE NEW RADIO.THE PCM WILL NOT LET CAR CRANK.IT THINKS IT

car or radio could have additional connectors, such as for a subwoofer, CD changer, etc. I put in a kenwood stereo in my car I ran the red wire to the yellow 12 amo wire on the ac control. Now my deck

...radio in the car and the car lot I got the car from could not figure out how to unlock the radio they got at junk yard!!! is the radio in safe mode? you will no this as it will say safe on the front ...

htr fuse blows after plugging in radio I have a 2003 oldsmobile alero that I changed ignition switch on. to get to it I had to remove the radio when I plug the radio back in it blows fuse 46 you must ...

changed mass air flow sensor now keeps stalling Indeed, I'd be for recovering the original MAF sensor and cleaning it. One VERY important part of cleaning is to NOT use Acetone or anything similar ...

radio wires i want to install new radio. need to know the location of wires. u need to take trim off around old radio and unbolt the unit and pull it out the wires will be behind radio

...car, the radio may be locked to the VIN number of the car, or by code entered into the radio (see your vehicle's user manual). If it is locked by code, you must have the code that was previously set. ...