...lock nut, (Jam nut), on the adjustment barrel for the clutch cable. You should grease the threads of this adjustment barrel to prevent corrosion in the future. Pull the rubber boot back into place. ...
...lock nut and adjust the cable as short as possible. Now, remove the derby cover from your primary. In the center of the clutch assembly you'll see a screw that takes a hex key or allen wrench. Loosen ...
...lock nut down tight. Replace the derby cover. Go back to the cable adjuster and turn the adjuster barrel outwards until you have about 1/8 inch freeplay in the lever at the pivot. Lock the lock nut ...
...lock nut down. Replace the derby cover. Then go back to the cable adjuster and turn the adjuster barrel outwards until you have about an eight inch of free travel in the clutch cable. Squeeze the ...
...cable at the adjuster. Lock the primary drive with the locking tool (may be purchased from Harley or Drag Specialties if you don't have one). Unbolt the primary chain adjuster from the inner primary. ...
Question about 2003 FXD Dyna Super Glide
cable strap to capture and hold the main harness conduit to ignition switch. ON FLHX and FLHT/C/U: Install the fairing cap next. THEN, using the elongated holes in the fairing brackets and a long ball
Usually answered in minutes!
137 Questions
126 Questions
109 Questions
61 Questions
45 Questions