Questions & Answers for: cable lock Motorcycles

...lock cable is of the lock so it wont lock it,you will have to take of the door panel and the lock where you use to open by hand from inside the cable goes down to the lock ,connect it theres a little ...

...stiff. the bonnet cable should be a 2 piece system,trace the cable from the lock and you should find the join,undo and try again to lock manually with a screwdriver.possibly the cable could be

...the cable back into the connector, lift the locking bar up, insert the ribbon cable into the connector as far as it can go and push the locking bar down to lock the ribbon cable onto the

...Lock Cable Failure here is the Replacment Procedure Park Lock Cable Replacement Removal Procedure Disconnect the negative battery cable. Remove the console. Remove the knee bolster. Loosen the lower ...

...loose. Follow cable down from lever you'll find an adjustment nut at the end. Loosen the lock nut and wind the cable holder out to take up the cable slack. Check operation if happy retighten lock

...lock cable but can't see any problem witgh cable. Wondering if it is the mechcanism the release rods & cables go to in door by lock latch??? and how I can release the mechanism??? Same thing ...

...cable lock, pull the cable case backward. You then get in the vehicle and step on the accelerator with force. This will set the cable. To make the vehicle shift sooner, move the cable case at the ...

...lock and cable. There are also scissor clips which fit into the slot and let you thread a cable or padlock through a hole in them. Then you secure the cable or lock. Some examples: ...

...lock cable.

2. Shift the transmission into the PARK position.

3. Turn ignition switch to LOCK position. Be sure ignition key cylinder is in the LOCK position. Cable will not adjust ...