Questions & Answers for: Toyota Tundra cable lock

...my key into the ignition, I still could not get it to stop. Finally, I disconnected the battery cable, and now it is quiet. Not sure what to do now. Hook the battery back up. It may of shut off. ...

...cable mount attached to latch. How do you remove bars to outside handle with out breaking something? There are plastic clips that hold the rods in place - one for the rod that goes to the exterior ...

...the radiator neck. Top off the coolant and continue. There is a known issue with the heat control cable, behind the heater control panel. The post that the heater valve connects to, on the ...

...lock assembly.  I would bet that the L-shaped end of the interior door handle cable broke.  The replacement is self explanatory for the handle. Google the door lock assembly which isn't as ...

...cable with a socket wrench. Remove the gravel shield if you need to access the alternator from under the car. Remove the electrical connector and unfasten the retaining nut on the alternator terminal ...

...cable from the terminal to clean it. The alarm goes off for 15 seconds. I reconnect and the alarm goes off again. It stops after 15 secs. I open the driver door, it goes off again. I try to crank it, ...

...the truck. Any ideas? There are several possibilities ranging from a defective starter, to bad cable connections, to the onboard security system locking out the starter relay, or an aftermarket ...

toyyota tundra hood cable not connected to verticle rod connected to latch under grill.Hood is popped up 1 inch. How and where do I reach cable. how and where do I find secondary latch under hood Hi ...

...own car that you own and have keys for. If you don't have the keys- disconnect the negative battery cable to stop the horn until you get your keys. Then reconnect the negative terminal and proceed to ...