...seems to be locked in the reclined position.. The seat position is changed through the use of a cable that runs through a flexible tunnel, under the seat. In one case that I'm aware of, this
...cable will not come of, even after loosening. It's not my first time replacing a battery it seems to have some kind of lock. Ford Focus 2003 Hi Paul, I've run across those stubborn ones too. There is ...
...lock and cable assy. Ensure the plastic link is properly inserted in its place between lock and cable assy. Test the mechanism with the car key. 2. Insert the whole assembly from engine side out. 3. ...
ford mondeo pasenger seat wont lock and keeps moving back and forwards ? You may have to replace the seat but, first try to lubricate the cable under the seat.
...cable to battery negative post and the other to the positive post. Ensure they never touch each other. Connect each wire to the two wires on the lock mechanism body, if one way did not work try ...
...connected. Or, the power door lock, if equipped, may not have power to the solenoid that releases the trunk, or the cable to the release is broken or not adjusted correctly. Good luck on this
...locks when you close it one click easy and the other hard click check your second lock and the cable attached to it maybe the cable stucks due to a bad spring or due to rust in the cable get it ...
Car will not start, makes clicking noise, and dash lights show a car with a lock above it dirty battery cables dirty starter cable red one dead battery
lock nuts on the brake cable. You may have to work loose the rust in the pivot at the backing plate. Once you get the pivot to fully swing into the drum, the adjuster will contract enough for the drum
...i unlock the car not all of the doors unlock. or if i lock it not all the doors will lock check the cable going to the driver's door by the driver's door lower hinge. check for a wire that is
Usually answered in minutes!
3,749 Questions
2,612 Questions
2,055 Questions
1,226 Questions
897 Questions