Questions & Answers for: Renault cable lock

...lock are disconnected the others work fine. My semi-educated guess is there is a sensor in there that has failed open-circuit and one pair of the six wires that go to it are for this sensor and that ...

...lock-button in font of the gear-stick, I will hear the relay click. This means the relay has got power... I have also dismounted that relay (located on a card that also takes care of the ...

...cable is broke that disengages the the lock mechanism,and yes the car will move with the handbrake off evan in gear ,only park will lock the wheels When the gear stick gets stuck you can manually ...

My '98 Laguna was in for CV joint and clutch cable repairs and sice then my remote central locking doesn't work anymore. G check the battery in the remote if possible, i think its just a coincidence ...

cable still connected or did it break if it is intact you can try spraying penetrating oil on the latch that holds the boot closed Open boot from inside. Then remove and unplug boot lock switch. Shunt

...or distrubed cable clamping.see from front under bonnet below the upper panel you will find bannet cable wire going to bannet lock, try n pull it. or pull the locking lever. it will definitely ...

...lock on towards the passengers. then remove the plastic cover under the wheel arch. it will reveal another plastic cover which if rubber will just pull off, else twist off. this will then reveal the ...

...lock so only way to access the vehicle is with the remote key fob. Are there any positive battery contact points I can access to connect jump leads to charge battery to open the vehicle using the key ...

...like I'm assuming you are speaking of a locked fuel door, either electrically controlled or by cable. Most manufactures have an emergency pull cable tab in the trunk compartment directly under ...

...lock that the cable attaches to .. The trouble with this method is - it's obviously not made to be opened like this as a security method - so sometimes and usually often, the grille/front has to be ...