Questions & Answers for: Toyota Supra cable

Question about 1990 Supra

2 Answers

...me what this could be?? quick test but be careful of a spark... start the car... unhook the battery cable... if it keeps running battery... if it quits... alternator needs to be replaced. Robert also ...

Ad

Question about 1988 Supra

2 Answers

1988 toyota supra, alarm reset alarm went off (didn't know I had one), now the car won't start. lock the car , unlock the car : start car simple as that! I believe you just need to lock the doors from

Ad

...non-turbo and I have seen a similar problem on my car. Probably one part of the two part speedo cable has broken, or the speed sensor has failed. The speedo cable turns a speed sensor which is ...

Question about 1998 Supra

2 Answers

how to install starter disconect the cable fom the negative terminal cable of the battery.---raise the vehicle and support it securely on jackstands ------disconnect the battery cable and the solenoid

Question about 1984 Celica Supra

1 Answer

...does the same thing.im puzzled? If I'm not mistaken this vehicle is equipped with a downshift cable. Make sure it is properly connected and is free of interference. Should be connected at the ...

Question about 1988 Supra

1 Answer

clutch problems car wont start have to pump the clutch or put cables makes a noice as if something is not connecting that wont allow the car to start. 1988 toyota supra If you have to pop the clutch ...

Question about 1988 Supra

1 Answer

...there is two reasons, valve stuck, or bad actuator, what you got to do is gently disconnect the cable from the valve and see if the valve move with your fingers , move it in opposite directions ...

Question about 1988 Supra

1 Answer

how do i change heater valve on toyota supra 1993 its mounted to the outside of the firewall under hood remove hose clamps and hoses and heater control cable only 1 bolt holding valve

unstable idle of my car, eci multi. what could cause that? Check the resistance of all your ignition cables, if they varie - get new ones - before putting them on, clean contact surfaces

Question about 1984 Celica Supra

1 Answer

Why would speedometer needle bounce The needle bounce may be related to the cable, it may be broken or just needs lube.Remove the speedometer cable, locate the connection at the transmission and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...