Questions & Answers for: bypass ac pressure switch

Question about 1995 Accord

2 Answers

ac turns on and off when i push da button. what do i need to ck bc pressure switch and relay was changed and fuses are good take it to the deeler I would not take it to a dealer for an ac issue. An ac

Ad

...bypass the low pressure sensor and allow the AC clutch to engage and begin to cycle again. Remember this low pressure switch is there for a reason. If you don't add more r-134 to the system and allow ...

Ad

...ac compressor to activate and circulate the refrigerant... it is a common practice to bypass that to install refrigerant, but you may have a leak so if you suspect a leak then add leak detector and ...

Question about 2005 Ram 2500 Truck

1 Answer

...ac run bypass 2005 -2500 Dodge Ram Mega cab. A/C not working, Compressor Clutch will not engage. Will not except Freon 134A. Do I need to run bypass on high pressure switch? more like run a bypass on ...

Question about 1998 Town Car

1 Answer

...you are bypassing the pressure switch. I am guessing that to fix your problem, you need to check the charge on the AC system, or check the pressure switch, and hopefully you will find your

Question about 2006 Ram 2500

5 Answers

...bypass it. WHAT IF I JUMP THE AC COMPRESSOR AND MY TRUCK SHUTS OFF u need to check for pressure in the ac system. ac clutches wont engage if no pressure in system, this is a safety measure to keep ...

...bypass the high and low pressure switch no change Looks like the low pressure switch gets power from a 10amp ac fuse. Power then goes to the ac relay which is powered on by the ac heat controller on ...

Question about 2005 Accord 2.4

1 Answer

ac clutch won't engauge hot wirs clutch it runs,bypass relay runs,replaced relay no good. Relay will not engage if pressure switch thinks freon is low. This switch does sometimes fail. If you are sure

...ac relay sw, diagnostic test code 23 blend dr actuator failure,but all vents work there are pressure switches in the system that stop power to the relay when the system has a failure high pressure or ...

Question about 2005 Accord 2.4

1 Answer

...ac compressor and no fan. Blower in the vehicle works fine Check low side pressure or try bypassing low pressure switch with a paper clip in the connector. If pressure is good but bypass works, you ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...