Only runs for 15 seconds or so. This unit sat around for years until it was given to me. I changed the sparkplug type ignitor and fuel, put some additive into the tank incase there was any water I ...
runs for about 15 minutes then shuts off . unplug and plug back in will run 15 more minutes.what are the adjustment settings? i tried to adjust. may have them wrong. unit is a155000 btu I believe the ...
Question about Heater-170,000 BTU Kerosene Deluxe
reddy 110000 btu fan motor needs front bearing , shaft id fine i took motor apart by grinding weld off of end bell. i am a motor repair expert, retired do not have accses to a lathe or i coud make a ...
rotor gap .003-.005 Which way does the rotor and bushing go on, bushing first then rotor? can't find the diagram
Question about HEATER RH125T 125,000-BTU PROFESSIONAL SERIES PREMIUM PORTABLE KEROSENE FORCED AIR HEATER W/TH...
Reddy Heater 110K btu motor won't start. If I remove the top half of the cover and spin the fan, it will light and run. It doesn't spin freely and just can't start turning on it's own. Bearing have ...
Question about HEATER R115 115,000-BTU PORTABLE KEROSENE FORCED AIR HEATER
Reddy heater 165,000 runs for approx 15 to 20 min. I unplug wait 5 min. it restarts again and runs for another 15 to 20 min. and so on ....and so on purchased approx 1 year ago There is a sensor in ...
Question about Heater-70,000 BTU Kerosene w/T'stat
I have a clogged fuel line (filter?) I do I remove the bushing without damaging it? FUEL FILTER (For 40/55/60/70/110/115/155/165 Models Only) 1. Remove side cover screws using 5/16" nutdriver. 2. ...
Question about Heater-30-55,000 BTU Variable
I need a photo sensor for a 55,000 btu kerosene heater. model# R55CT/ B55CT Where is one available? You can find the item at www.desa-parts.com for your R55CT or B55CT Reddy Heater. Here is a link to ...
Question about Heater-30-55,000 BTU Variable
My reddy heater fan hums and turns very slow. What might cause that? When I spin it with no power it freely spins, I removed the pump housing and still have the same problem. dry bearings or bushings ...
Question about Heater-30-55,000 BTU Variable
i have a reddy heater 60. it starts up but shuts down when motor gets hot. rotor is offset from center. Is it suppose to be offset from center? No it not, Sounds like the bushings are worn. It is time
Usually answered in minutes!
354 Questions
282 Questions
85 Questions
73 Questions
62 Questions