Questions & Answers for: Harley Davidson bush 15 4

the bike. Remove and discard the starter housing O-ring. Installation 12 Inspect the two split-ring bushings in the inner primary case where the starter mounts for slack or looseness. Remove the split

torque specs for the swingarm on 2002 1200 sportster removed swingarm,replaced bushings,my manual has no torque values in it missing that page.torque on swngamr bolts caliper bolts axle nuts. Hi Todd,

bike's front end seems very light and it seems like the beginning of a wobble.... The swing arm bushings have been changed the front end tightened numerous times... I have changed motor mounts and

the bike. Remove and discard the starter housing O-ring. Installation 12 Inspect the two split-ring bushings in the inner primary case where the starter mounts for slack or looseness. Remove the split

the bike on the centre stand and tried to feel for loose play to check wheel bearings and swing arm bushings. any suggestions? Hi Anonymous, and the usual suspects are: 1. Improperly loaded motorcycle

...the fork tube as a slide hammer tool, slide the fork oil seal, the slider spacer and the slider bushing off from the end of the fork tube, discard the fork oil seal and the slider bushing, gently ...

...it install one pillion support but do not tighten its fasteners, install the wave washer and bushing on each pillion support, install the pillion and the second pillion support and tighten all ...

...REAR CALIPER BOLT PINS AND BOOTS FIRST apply about 0.4 g of G40M BRAKE GREASE inside the caliper bushing boot and the caliper pin boot and inside the boot lip to prevent sticking between the boots ...

like it is coming from the front cylinder head, but this has been changed. Have installed the brass bushings on the rocker arms, but that did not help. Have checked connecting rods, pistons and piston