Questions & Answers for: buick tensioner

...belt tension How do you relieve the tension on the Buick serpentine belt? One pulley is a tensioner. Put a wrench on the nut in the center of the pulley and relieve the tension from the

BUICK LESABRE TO REPLACE THE BY PASS THAT GOES FROM THE TENSIONEER TO THE MOTOR. Look for the 1/2" square hole on the tensioner. That hole is were you place a 1/2" breaker bar, to relieve the tension,

Buick Regal GS (supercharged), alternator v-belt fell off. The belt tensioner must have failed. Can I get some help on how to replace it & fix this problem? buy a new tensioner assembley and idler

buick La saber Find the tensioner it will be a pulley that does nothing but put tension on the belt. There should be a square hole in it. that should fit a 3/8 inch drive socket wrench or breaker bar.

1998 Buick Park Avenue, replaced serp belt, but now no tension. Hello. The tension can be adjusted. Just loosen the tensioning pulley, use a crow bar to put tension on the serpentine belt and tighten ...

...buick L/S does not have a 3/8" slot on the tensioner to release the pressure. there is a 15 mm bolt head on the tensioner. is it ok to apply torque to it to relese the pressure or will something ...

...tensioner cut out on a 1990 Buick Century? Need to release the tensioner to get the belt back on and can't locate the cut out. Is it on top, side bottom of the belt tensioner? It should be ...

...Buick Century, can you tell me if the tension should automatically tighten as I tighten the bolt, or do I need to leverage and pull the pulley while I tighten the bolt? If the tensioner doesn't ...

tensioner 1996 98 Buick Lesabre... These two videos will help you get the job done. Good Luck !!! Remove the serpentine belt (inspect to determine if it also needs replacing) The tensioner is attached

...Buick terazza serpentine belt, install and replace 6 cylinder Rotate tensioner to release tension. Remove old belt. Thread new belt on and rotate tensioner again so you can slide the belt over the ...