Questions & Answers for: buick ignition module problems

...buick park ave runs rough and cuts off while idling.It has new parts such as ignition coil pac,plugs and wires,all sensors,control module,fuel filter.Now im stuck cause i still dont know what the ...

ignition module faulty ignition module. Draining battery. Where is the module located on the vehicle? Hi... The Ignition module of your Century. Is located UNDER THE IGNITION COILS. The ignition coils

...ignition module on 93 Buick Century has no power going to it when you turn the key could it be a broken wire or the computer itself...the car is getting no spark and the coil packs were tested check ...

...Buick Riveria shuts off after driving 8 to 10 miles, can happen anytime or place then starts up again after waiting 15 minutes or less Sounds like it might be a bad crank sensor or ignition module. ...

...ignition control module There should be 6 bolts that hold the ignition coils in place. If you remove those bolts, the coils and the module will come out. However, if stalling is your problem, I have ...

p1361 code on 1999 buick park avenue how to fixs code p1361 on a 1999 buick park avenue? Code 1361 is a problem with the ignition module. The module would need to be tested.

...Buick lesabre keep shutting off and sometimes it want start back up for a few mins. And it also backfires and skip ignition module or controll board problem bad coil or ignition module most likely. ...

...buick mechanic on JustAnswer com It's not the BCM. The BCM doesn't affect the ignition switch power. But the ignition switch will affect the BCM. I would look to see why you don't have power to the ...

Ignition Module problems / 2008 Buick Allure, had to change Ignition Module twice in under 75,000 km . what is the problem with them and is there a recall? like what?

...buick century? There is a fuse for the ignition module , ELEK IGN 15 amp . Really don't think this would be your problem , more then likely the crankshaft position sensor or the ignition module is . ...