...front end. I put new brake discs on about 2000 miles ago. I started to have this noise problem about 200 miles ago and it is steadily getting worse. I backed off the calipers and the noise seemed to ...
Question about 2007 Rendezvous CXL SUV
Front end squeaking possible rotor rubbing something. I have an03 rendezvous with 112,000 miles. I am getting a rubbing sqeaking noise from the left front mostly. It happens when I do a sharp jolt in ...
...Buick Cadillac Chevrolet Chrysler Dodge Ford GMC Honda Hyundai Jeep Kia Lexus Mazda Mercedes-Benz Mitsubishi Nissan Oldsmobile Pontiac Suzuki Toyota Volkswagen Volvo 13 You need an alignment. your ...
...the driver side If these are the correct size tires then it could be that the suspension is wearing your front end shop should be able to check this ,if not let me know I will give you some
front end squeal everytime I turn to the left. Also sometimes when I am driving or turning to the right. either the strut plate bearing is bad on top of the struts or the ball joints on the bottom are
...front drivers side head light. There is little I can do about this, but I figure I could probably get some extra wire, splice one end to the power wire of my working head light, run it back through ...
...front end when i'm turning a corner or when turning the well at all. Any Ideas? What you describe is most often caused by a bad tie-rod end, which is part of your steering. This causes the ...
Buick Park Ave 3.8 motor Just got the car from a relative, they were told it needed a transmission due to it shifting erratically. Once I drove it, it is shifting erratically and the volt meter on the
Question about 2003 Rendezvous
front end The front end noise is extremely loud when a tight turn is made right or left even with newly replaced tie rod and wheel bearings. It is a very distinct grind. Last week I began hearing loud
Question about Charging & Starting Systems for Buick Park Avenue
...buick park avenue starter location Loaction and replacement process If you're asking about location, I think this may be too much of a project for you... The starter is under the engine, might be ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions