Questions & Answers for: Chevrolet Express bt 12

Question about 2001 Express

2 Answers

I have a99 Express 12 pass. van i get backfire and lack of pickup until i get to about 40mph sometimes and then others times it just runs fine. 2002 Chevy Express Van>>>>with headlights off--the rear ...

Ad

Question about 2008 Express

1 Answer

cant find fuse for 4 rightside 12 volt outlet look under the hood for a box labeled fuses and relays as well as sometimes in the glove box on the drivers side dash as you open the door and under the ...

Ad

Question about 1997 Express

3 Answers

no spark to the coil No spark to the coil or is it no spark from the coil? First verify that you have 12 volts to the coil when you turn ignition switch on if not you will never have spark from the ...

12 volt aux plug wont work looked and tested all fuses is there a different location for the fuse for this plug? most vehicles have a seperate fuse from lighter. on the 2006 it is right next to ...

hiI have a 2001 3500,dual wheel chev box van w/ 5.7 vortex motor. When it is cold it will not start. When it is warmed up it will start fine. When cold you can turn the key from off to on with out ...

howcan i get trouble codes without access tool? i have all shop manuals Jump the >A+ B terminals and Watch Check Engine Light, it Will Flash Codes, First One will be Code 12 1 Flash> Pause then ...

Question about 1999 Express

1 Answer

I HAVE A 99 CHEVY EXPRESS I THINK ITS THE IMOBILIZER IT START BT RT AFTER IT TURNS OF RT AWAY immobilisor ,concessionary solo

Question about 2002 Express

1 Answer

how do i test fuel pump You can test it by testing the voltage that it is putting out. You will need a voltage meter to do so. The normal voltage is 12. It should atleast be close to that.

...BT I CNT AFFORD TO GET AN ENGINE. SO ANY ADVICE ANY1? go to a bone yard/-u pull-it or online [for a parts truck ] motor 150 and up buy a chilton or --haynes manual 12 to 20 $ can rent engine hoist-or ...

My 1998 express cant read obd 2 Checked voltage on pin 16 4 and 5 and have 12 volts on them pins Took voltage readings and have 12 volts across pin 16 and 4, 16 and 5 Cleaned up A and B aux made sure ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...