Questions & Answers for: brother machine wheel turning needle

Brother 1034d serger needles go up and not down Hand wheel works. It clicks when turning the hand wheel and the needles are going down. if a part has come loose or broken then the machine is not going

machine and put it into straight stitch in the center needle position.- Turn the hand-wheel forwards until the needle is bottom dead center.- Turn the hand-wheel forwards until the needle raises 2.2mm

brother cs-8060 wheel knocks I just turned on my machine and when I press on the pedal, there is a loud knocking sound as the manual wheel turns. If I turn it by hand it still knocks/clicks and ...

...Brother LX2500 machine will not move when I press the foot pedal. Everything else seems to be working fine. I can hear the motor run, but the needle just won't move. If the balance wheel is moving ...

Brother ES 2000 I removed the bobbin case I turn the had wheel and the needle hits on the back side of the machine bobbin bed Ck. the needle checked the belt on hand wheel...I think it is out of ...

...Brother SE-400 where the needle bar is completely seized. I was sewing, ran over a pin, and my machine just stopped. The wheel would not turn at all. I removed the plastic case and loosened the set ...

brother sewing machine where to find the timing marks turn hand wheel towards you until needle at lowest point, continue to turn slowly until it has risen approx. 3/16". hook should now be immediately

...machine wheel My industrial sewing machine is jammed, I cannot turn the wheel at all. Any help would be appreciated. Thank you oh, there has got to be a reason. Is the needle stuck down, did you take ...

Brother Sewing Machine Innovis 1200; I broke a needle and now can't turn the balance wheel; what shall I do? Most like the needle affected the machine's timing. Take it for service. ..

...Brother PE770 had the safety stop come on and the wheel won't turn so the needle is locked in place.... you can actually force turn it someto move needle up and down I took it to Brother center and ...