Questions & Answers for: Volvo brake pads

Question about 1995 850

4 Answers

...brake pads, now brakes skweek really loud when you put the brakes on to slow down to stop at a red light or stop sign. why? Several possible causes: Did you use copper-based brake grease on the brake ...

Ad

Question about 1996 960

1 Answer

brake pads from the rotor with a broad screwdriver. Close the nipple. Be careful not to damage the pads if you are not replacing them. (It would be wise to replace the pads when you replace the rotors

Ad

...brake pads and disconnect the brake pipes from the caliper. Remove caliper mounting bolts and lift the caliper off. Drain the remaining brake fluid in the caliper into suitable container.To install: ...

...you have what is called a brake pad walking. How to fix this is to replace the brake pad hardware so that the brake pads will be more secure .It should not be a safety issue but i know its annoying

...grease on back of pads push in caliper piston slowly using large grips or g clamp fit and secure caliper pump up brake pedal check brake fluid level do other side for rear brakes see my ...

Question about 1995 850

1 Answer

...the front brake pads are very worn.. Check you master cylinder too. This will clue you in always if in need of brake pads. If the brake fluid is half way down, the pads are nearly worn to ...

Question about 1995 850

2 Answers

brake pads and rotors.It sounds like that your brake pads are down to metal. replace brake pads and brake rotors. There are wear sensors in the brake pads. When the pads become worn down these sensors

...brake pads replaced and now have a rattle from the pads. Goes away if I pull up the handbrake one notch or step o n the brake pedal lightly. There should be an adjustment to take up the slack in the ...

...brake pads like they should of. or the pads are glazed from overheating NEW BRAKE PADS SHOULD NOT BE NOISEY.IF ROTORS BEEN TURNED.NEW PADS IF THEY DID INSTALLED NEW ONES THEY SHOULD NOT BE NOISEY. ...

...brake pads have worn down and there is now metal to metal contact with your brake disk/rotor The driveshaft is worn The wheel bearing has worn A grinding noise - when braking - is usually associated ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Volvo S70
1998 Volvo S70

664 Questions

2000 Volvo S40
2000 Volvo S40

682 Questions

2000 Volvo S80
2000 Volvo S80

587 Questions

1999 Volvo S80
1999 Volvo S80

551 Questions

1996 Volvo 850
1996 Volvo 850

468 Questions

Top Volvo Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...