Questions & Answers for: Hyundai brake pad anti rattle clips

brake pad sets. ? All four pads must be replaced as a complete set. ? When replacing the brake pad, check for deformation. When replacing the guide spring, use a new one or the used one after cleaning

Ad

Question about 2006 Sonata

1 Answer

...brake pad that works best before i ruin the rotors again. Front or rear brakes? Make sure the rotor isn't contacting the backing dust plate. Make sure the brake pad slider clip/clips are not ...

Ad

Question about 2001 Tiburon

1 Answer

...brake pad arms rest inside the calliper but ****do not get copper grease ****onto the surface of the new brake pads or wheel disc. You can then reassemble the calliper over the new pads and re-bolt ...

pad though) and also spray some "disc brake quiet" on the back of the pads. it comes in a red can and the spray that comes out is like sticky red paint. do those 2 things and the squeals will be gone.

anti-rattle springs. Recompress the caliper piston all the way back into its cylinder. Flip the caliper back into position and reinstall the 14mm bolts. Of course, you need to purchase the replacement

Question about 2006 Tucson

1 Answer

...brake pads off once i disconnected the calliper from my rear brakes of a 2006 tucson, i can't get the pads off to replace. there are metal clips lining above and below the pads and i don't know where ...

...This was happening before i replaced all of this too. dear friend:the tapping noise comes from the brakepads and it means that the anti rattle plates were not installed on the last brake pad ...

...brake pad and shim then remove the inner brake pad ans shim(s) 7.Remove and inspect the upper and lower pad retainer clips,the pad retainer clips should fit snugly in the caliper mounting bracket;if ...

2003 Hyundai Accent: ~30,000miles; the brakes squeak and there is rattling sound from underneath. I haven't replaced brake pads yet, so I believe that may be part of the problem, but I want to be sure

Question about 2002 Accent

1 Answer

...or sometimes the pad is sightly to big & people grind the pad to fit in the anti rattle plate. 2 loose brake calliper or badly worn caliper slide. 3 loose driveshaft centre nut. (hope this

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 Hyundai Santa Fe
2004 Hyundai Santa Fe

1,503 Questions

2001 Hyundai Elantra
2001 Hyundai Elantra

1,180 Questions

2000 Hyundai Accent
2000 Hyundai Accent

1,131 Questions

2006 Hyundai Sonata
2006 Hyundai Sonata

1,254 Questions

2001 Hyundai Accent
2001 Hyundai Accent

1,082 Questions

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...