Questions & Answers for: Mazda Protege bosch 2 20 sre

20 mins to 1/2 hour my ABS and E brake lights come on then the transmission acks up. Please HELP! It sounds as if you may have a short in the wire harness, or a bad plug on one of the sensors. This is

Ad

bosch connector (2 whte, 1 blk & 1 gray) IF THE CONECTOR ON THE END IS THE SAME THEN IT WILL WORK AND THE COLORS DO NOT MATTER. YOU HAVE TO MAKE SURE THAT THE CONECTORS ON THE END ARE THE SAME THE

Ad

...2 quarts. Drove it for 20 minutes and hot oil smell - no light on. Touched it before I was to fill up with another quart and extremely hot. Woud could this be? it sounds like u have a mild oil leak ...

Question about 2002 Protege

2 Answers

2 outside temperature guidelines: Above -15degrees F 10w30 weight oil, Below 32 degrees F 5w30 oil. I beleive that car may require a 5W-20 grade oil, however please check with the owners manual. There

Question about 2003 Protege

1 Answer

My 2003 Mazda Protege has 111,700 miles and makes a roaring noise with some vibration at around 20 mph but goes away when I accelerate to higher speeds. I have 17 inch custom rims with low profile ...

Question about 2003 Protege

1 Answer

...2 bolts holding the handle disconnect the control arms on the handle pull it out put the new one back on and replace everything the way you took them off the parts should not be more than 20 ...

Question about 1999 Protege

1 Answer

...on the highway and 20-25 in town, so it's not really affecting my gas mileage. Thanks. It may be the fuel pump, the fuel filter may be dirty and need replacing or it could be a faulty injector or

2 , which would be sufficient for me, and drive 30 min to work. Now when i start my protege i have to turn it up to 4 and it will take anywhere from 10-20 min to start blowing cold air. When I get too

...wheel bearings. 1.57 in. bore; 2.91 in. outer diameter; 1.57 in. width; These bearings require a 2 ton press and the correct size die to remove and install. Some shop can do the job for $20 a

...2 , still no activity.is there a certain brand o2 sensor i should use, im using bosch at the moment.PleaseHELP. Has the sensor 4 wires, if yes it has a fuse. The two white wires are for a heater, use ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...