Questions & Answers for: boot latch

...boot latch is not tight enough or has snapped or it is not connect to the latch in the boot and has come off it should have a liitle bull bearing at the boot end and will click on to the latch at the ...

...try latching the boot latch manually ie.with a screwdriver.and holding the other switch compressed and see if the warning goes off, that way you may be able to isolate which switch is the

...boot for the latch to engage - I never used to have to slam it to close. The panel beater has palmed it off as to do with the 'seal' and preventing leaks (BS!) but I can feel the latch ...

...is a front load washer,remove the outside spring that holds the rubber boot on,loosen the boot on the side where the latch is,remove the screws,remove the wires from latch and put it back

boot latch switch is faulty the gem module that controles this funtion may think the boot is already open, or the latch release solenoid/motor may have failed, or a broken wire. around the boot hinge,

...boot lid not to shut? Latch looks like its not going in all the way to shutting, therefore, boot not locked in use a round bar ( philips screw drive) , place it under the latch tongue and while ...

...boot latch may have failed or siezed. the boot light is turned on /off by the switch in the latch try putting some wd40 or similar on the latch mechanism to free it off has it got a cable release ...

boot is catching the latch on the right side when i but the roof down or up it seems the latch on the right hand side isnt releasing the boot/trunk (this isnt the main catch its on the side) sometimes

...with WD40 or Garage door lube. Try and get to the solenoid as well as the latch itself. You will have to remove a bit of trim. https://www.google.com/search?q=2011+Holden+cruze+boot+latch+sticking

...and open the boot as if it was closed properly. A boot latch cannot be released by pushing on the actual hook latch. If it is fitted with a remote button or lever try using that to release the