Questions & Answers for: Dell Inspiron boot code

...and the system crashes and reboots when a ran the on board diagnosistic is showed an error code 0146 and msg code 2000-0146 2000-0146 is indicating a hard drive failure which is why it won't

boot up turns on and sounds like its start the cd rom starts but nothing comes up on screen but a brief letter and number code to fast to catch then nothing just a gray screen~ any thoughts? thanks, J

...Code 0146 refers to failure to find or load NTLDR files, needed to run your operating system. Place your Restore disk in the DVD drive, power up the computer, hold down the F12 key till boot screen ...

...boot onto Windows (select 1) It brings you to a command prompt : Type in CHKDSK/R Hit the ENTER key This is a Diagnostic error code ,Drive self test failed ,its nothing you did ,this kind of issue ...

...boot from the disk. In the DST short test, I received the error code 1000-1046. Does this mean the hard drive has failed or is dead? Any advice would be appreciated, before I invest in a new hard ...

After turning on it won't boot up past the "Dell" screen You can check the hardware in the computer. by doing the self assesment. 1. turn off the computer. 2. At the Dell logo screen, press . 3. At ...

...Code 2000-0146. Continue with memory test? Yes. The memory test was completed with no further error codes. Then I booted the system and has run OK since then. 2000-0142 and 2000-0146 are hard drive ...

...boot with disc either. During a test I got an error code 0F00:075D. I cannot start computer, even in safe mode. I can access the boot system and F12 which appears to be the information about my ...

...seconds. Im on my desk top to try and resolve this error code if possible This error code means that no suitable boot disk can be located by the PC. Your hard disk or boot device may have failed

...Code 45) laptop inspiron 17 dvd player has never worked and message displays for device Turn the computer off. Turn the computer back on. Immediately at the Dell logo screen, starting tapping the F12 ...