Questions & Answers for: Poulan boggs down

...runs fine but when trying to cut saw boggs down the saw will cut but very little pressure can be applied,brand new chain you need to adjust the gas an air on those two little screws on the ...

boggs (is that a word?) down, then dies. It does start again but it just boggs all the time when i pull the throttle. I cannot get it to run at a speed to cut, needles to say full throttle. I am using

...boggs down and dies Unit is either having trouble picking up enough fuel or muffler is plugged. First disassemble the muffler and check that the flame arrestor screen is not clogged. Clean as needed. ...

...boggs down and nearly stalls. As it warms up it seems to get worse, esp. if I turn it on the side to cut. I've cleaned it all up and checked the fuel lines. They are intact and no leaks or clogs ...

...boggs down when trigger is squeezed. Can't keep is runnig long enough to try adjusting the carb or idle speed. Any suggestions. Thanks. Its running too lean, this could be because the fuel filter in ...

...boggs when given gas if you pump the throttle it will run at full throttle buy once it idles down it stalls This is fuel starvation, replace the fuel filter in the tank, check the fuel hose up to the ...

weedeater starts and idles and runs but not at full power, also boggs down at full trigger pull remove the muffler and try it if ok open the muffler and clean out  the carbon from the screen 

...boggs down. Gan anyone help? Hi dennisSounds like to me that you have a problem with the high speed circuit of the carb...could be some trash in the jet or the jet may be out of adjustment...try ...

I have a popular p1500 it boggs down and dies and smells like it's burning may not have enough oil in gas

...when blades are engaged poulan pro 48 20hp engine boggs down and dies when blades are engaged Something may be wrapped around the blade shaft under the mower deck or maybe the shaft bearings are