...carb? The idle jet is located in the bottom of the car. it's the recessed one in the bottom of the body. Remove your air cleaner assembly. remove the four screws. Be careful because it will be full ...
Question about 2001 XL 1200 C Sportster Custom
...the fuse holder down. realease the little clip and tug it downwards. It sits in grooves and the body of the fuse block just slides up and
...an instant oil leak from now on) Be sure to put some prelube made for this, on the lifters round body, and on the roller on the lifter. A tiny little dab in the center of the lifter where the ...
...is a physical ground. If it doesn't work, try to connect the black wire to the turn signal body to make sure it's got a good ground. Now, there is the possibility that the turn signal ...
good evening there..!i have a 1999 883cc sportster and i took of the original turn signals and i used a pair of lower swing arm turn signals/marker lights for rear and a pair of small bullet turn ...
Question about 2005 XL 1200 C Sportster Custom
...idle counter clockwise to decrease idle. There is also an air/fuel mixture screw inside a carb body lug that may or may not be plugged with an aluminum cap that's about 3/16" thick. This cap can ...
...there is power going to it and the ground wire is securely fastened. Then look behind the horn body for a small set screw sometimes with a jam nut. This screw puts tension on the horn diaphram
Question about 2006 XL 1200 C Sportster Custom
...the grip end of the cables are seated correctly. If that fails check the push pull at the throttle body to make sure the cables are in the grooves. I'll bet it was the tie downs doing some damage at ...
...regulator to the quick disconnect check valve. 12. Fuel tank vent system plugged. 13. Throttle body controls misadjusted. 14. Damaged throttle body or intake seals. 15. Loose, dirty, or corroded ...
Usually answered in minutes!
586 Questions
351 Questions
242 Questions
159 Questions
145 Questions