Questions & Answers for: bobbin case stuck

bobbin case. i also obtained a replacement bobbin case from brother, it worked for a while, but now i'm back at the same problem. any an all solutions would be greatly appreciated.. i have been sewing

wheel backwards so it frees off or take the bobbin and bobbin case out and have a good look, when you take the bobbin and bobbin case out if the machine does not move then you have a problem elsewhere

...bobbin case on my singer feaherweight is stuck The machine won't stitch. Threads were stuck around the bobbin case. I could not remove the bobbin case; the machine seems frozen, so I tweezed all the ...

...bobbin case to get out a stuck thread, then inadvertently put the bobbin back in the case without pushing the bobbin hook cover back. Now I can't get the bobbin out of the bobbin case. take a small ...

...bobbin case on elna sewing machine bobbin case stuck does not turn round Probably unevenly wound on the bobbin. Or tension needing adjusting, be careful to note where tension spring started before ...

bobbin case, it could be because it is the incorrect bobbin for the machine or the bobbin was over-filled with thread. You may just need to use force to remove the bobbin. It may damage the bobbin and

...bobbin case. Use new bobbin case. If things are stuck, is it possible the wrong product is being used, ie wrong bobbin case, wrong bobbin? Sometimes, the wrong product may seem to work, but a tiny ...

...bobbin case. If it is stuck, do Not, do not force the assembly, rather look for tangled threads and calmly snip the thread and remove. Once the tangle is gone, remove bobbin and bobbin case. Rethread ...

...bobbin case . It comes only half way out 880 Bernina If your bobbin and bobbin case are stuck on your 880 Bernina sewing machine, there could be several potential causes for this issue. Here are some ...

...bobbin case will not come out for some reason. How do I remove the bobbin case to realign the case? The bobbin itself comes out, but the bobbin case is stuck in the machine and needs to be ...