...curved blue line. I have checked the rest of the resistors on the convergence circuit board and all seem to be in the proper range. I even tried to move the rings on the Blue Gun.....still have the ...
Question about HD56W66 56" HDTV
blue line that is curved at the top of the screen When I turn the tv on, the screen is distorted. All 4 sides of the tv picture are curved inwards causing the picture to be blurry. There is also a red
...1992 sound ok, Checked fuses, curved blue line, no red,green lamps/guns? can't find free schematics. Chet WHERE IS THE CURVED BLUE LINE? CENTER OF THE TV? IF SO THEN YOU HAVE A BAD VERTICAL
Question about 60PP9202 60" Rear Projection HDTV-Ready Television
...blue and red curved lines My HDTV has blue and red curved lines that just appeared suddenly. Was working fine in the morning, but once I disconnected my xbox 360 and turned it back on, the curved ...
Question about 60PP9202 60" Rear Projection HDTV-Ready Television
blue curved line at top of screen and yellow curved line at botto I bought this TV from a friend and it worked fine in his house, but when I moved it to my house (very carefully) it started having ...
...cable is off it shows a red, green, and blue curved line across the screen. HAVE RED GREEN AND BLUE LINES AT THE TOP OF MY SCREEN Ur convergence is dead.Require convergence kit tv model,replace
Question about KP-46WT510 46" Rear Projection HDTV
...curved blue lines through the screen and then turns itself off after 5-7 sec. possible crt problem, most likely though its a convergence problem. expect to pay around $300 If it's a DLP TV you might ...
...curved picture when u turn tv on red, green, and blue lines curve across the top of tv Hello red, green, and blue lines curve across the top of tv is cause by defective convergence STK IC or you have ...
...Blue curved flickering lines on the screen( I have tried auto focus and manual convergence neither of these have helped) If you take the back off and look into the coloured guns the red and green gun ...
...a unused video input--if see faint curved blue lines with some blue visable on the screen the blue screen control needs to be adjusted just slightly down until the blue and curved lines are not
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions