...that has probably blown due to running when empty long fuse is necessary to stop hi voltage flashing over airgap when fuse blows when fuse blown no output from magnetron as hi volts missing steve ...
Question about Spacemaker 1.7 Cu. Ft. Over-the-Range Microwave
...fuse has blown. you can check the cut-off fuse by removing the cover. it is located near the magnetron tube. replace it if it is blown. if the fuse is ok, this will confirm inverter failure. replace ...
Fuse Blown My Kenmore is 18 years old and it was still working fine. Two days ago, all the lights and indicators went dark. I checked it today and found that the fuse is blown. I can
Question about Spacemaker JVM1640SJ Microwave Oven
...a continuity tester. If the fuse is blown replace it but make sure you use the same amp rated fuse as you removed. If the fuse blows again then there is an electrical short somewhere in the
Question about Spacemaker JVM1640SJ Microwave Oven
blown fuse. Sometimes you cannot determine a blown fuse by visual inspection so check it with a multimeter for continuity across the terminals. 4Replace the blown fuse. Go to your local hardware store
blown a fuse? Where do I find the appliance fuse in the microwave? My email address: [email protected] Thank you in advance for your help, Mike If the microwave control panel doesn't light up,
fuse is blown by testing it with an ohmmeter. If the ohmmeter reads zero ohms, your fuse is not blown. Other readings on the ohmmeter show that your fuse is blown. &
...fuse is blown by testing it with an ohmmeter. If the ohmmeter reads zero ohms, your fuse is not blown. Other readings on the ohmmeter show that your fuse is blown. 5. Replace the blown fuse by ...
Question about Spacemaker JVM1640SJ Microwave Oven
...fuse is blown by testing it with an ohmmeter. If the ohmmeter reads zero ohms, your fuse is not blown. Other readings on the ohmmeter show that your fuse is blown. 5. Replace the blown fuse by ...
Question about Spacemaker JVM1640SJ Microwave Oven
...fuse if it blown. Second: If this fuse blown again, the magnetron must be replaced (shorted). Note: These answers only apply when the microwave are working with normal sound but NO heat, If strange ...
Usually answered in minutes!
3,405 Questions
257 Questions
57 Questions
46 Questions
27 Questions