Questions & Answers for: a c blower not working

...working Blower motor was not working. Replaced final stage unit. After 3 months of working fine, it is not working again. What would cause the blower motor to not work again? Heater control unit ...

...blower speeds are not working I would check the blower, but if only one speed is not working I would check the resistor block for the blower it controls the speeds. they use 2 different blowers in ...

...blower is not working, but the a/c is Check for power at blower motor connector with a/c on and blower on low if you have power I would suspect blower motor. The blower fuse is label inside the fuse ...

...blower is not working. I checked the fuses they are OK could be the blower motor or the blower motor resistor. if its the resistor the blower will usually work on high only with the settings not ...

1996 SILHOUETTE BLOWER WILL NOT WORK 1996 SILOUETTE BLOWER WILL NOT WORK. BLOWER (WHEN IT WORKED) WOULD SLOW BY ITSELF AND HOWL. SOME SPEED SETTINGS WOULD NOT WORK AT ALL (NO HIGH SPEED). I CHECKED ...

working, blower motors actual speed which is high is working. It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced. =====

...blower not working the air condition blower was working good then it would go off and come then it just stop working Are you saying the blower motor would run intermittently and then just stopped ...

blower fan not working. I think the wires behind the stereo have something to do with it? blower on heat or AC fails dead. but must work on HIGH, does blower high work? there is blower high relay that

...blower motor from working. 4. Control Module Failure: The HVAC (heating, ventilation, and air conditioning) control module is responsible for controlling the blower motor and other components. If the ...

...blower not working, removed the blower and checked with a 12 volts battery and it seems to be working, does anyone know where the blower fuse is? checked no: 40 relay, it is also working. see below ...