loose on 1991 chevy s10 blazer my steering wheel was very loose, I tightened the 4 screws that were loose. My problem is I can not depress the spring far enough to install the retaining clip. I need a
...loose on my 1997 Chevrolet blazer. I replaced the steering box, which helped a lot, but it still has about an inch of play in the steering there is an adjustment on steering box also ujoint to box ...
...is loose when u turn about a inch before the wheels turn blazer s 10 4 x 4 check tie rod ends they might be wore out when you turn the steering wheel they should move immediately with no ...
...blazer. new batter, starter. turn the key sometimes it starts ans sometimes all is does is click. wahts wrong?? is there something in the steering column i need to fix? Possibly the switch at the ...
...blazer, and sometimes when turning I go to straighten the wheel and they dont respond right away. Causing me to over steer in the other direction. Is this in the steering box? Check your steering ...
Steering column loose and causes auto to stall and jump out of gear when steering wheel moves. There are 3 tilt colum screws deep inside the colum, it's common for them to come loose and eventually ...
...CENTER.BEFORE BUYING A NEW RACK PINION.CHECK RACK MOUNTING BOLTS FOR LOOSENESS.CHECK RACK PINION MOUNTING GROMMET.ALSO CHECK FOR LOOSE WORN TIE ROD ENDS.IF WORN THEY WILL CAUSE PLAY IN STEERING
...loose on my chevy s 10 blazer overall steering feels good just steering wheel is loose LOOk on the top of the steering box in the middle there is a stud with a nut threaded onto it this is the ...
loose steering... I would replace the steering box. It's not uncommon in this year Blazer.
loose steering box mounting bolts on the chassis. Check that the top bearing in the steering box is ok as if it is shot the shaft will move up and down rather than push or pull the steering nut in the
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
