...switch plug for 84 cj7 I'm about to change out my headlight switch The wiring harness plug has a black wire in the plug and coming out i notice a 16A black-18 wire w/end connector just hanging ...
...to troubleshoot The rebuilt motor is wired wrong. The 4 wires in the plug, red, green, blue and black are in the wrong slots. switch the two end ones and the two middle
...You might want remove one then turn on the headlights and try a temporary ground wire to the black wire. If it works then either check your ground wire from the battery to the chassis or ...
...power steering fluid but am not quite sure which resevoir to put it in. The power steering pump is black and has a 2" diameter cap theat screws
black paint, lightly spraying a few of the stems to give them a shadow look. Finish by spraying three coats of clear coat paint onto the painted areas of the Jeep. This protects the paint from UV rays
how do i adjust carb on 84 cj 7 it is running rich and has some black smoke The first thing to do is make sure that the problem is not the choke butterfly. Make sure it is opening all the way because ...
Now starting when cold, it belches black smoke and runs very roug I replaced my carburetor with a new one but without the stepper motor. immediately after installation and for the first 3 weeks after ...
...no change to problem. I probed the plug at the icm. and have power at my orange, violet, green, black wire @ approx. 5 to 6 volts. When I probe the harness side of the icm I only get .005 of a ...
...it's job.If it's "borderline", I have had some success by filling the cavity inside the seal with black silicone sealer and letting it dry before installing. That helps keep the seal in contact
Question about 1983 CJ7
...on the fender or firewall close to battery. Look up a pic of a solenoid online to be sure. Its black plastic with 2 studs) and see if it cranks. If so, the solenoid is bad... Cheap, easy fix.
Usually answered in minutes!
