Questions & Answers for: Toshiba Satellite bent pins charger

...on the key to see if the sides are bent or broken. If the pins or sides of the clips are bent, take a small flathead screwdriver and straighten them. If they're broken it will need to be

...pins are bent, then it is possible to gently straighten them using the tip of a ball point pen or mechanical pencil. If the pins are broken, then replacement of the keyboard may be necessary. Try ...

...pins, even if one is bent or mis-aligned it will not work....use a small screwdriver to slighly adjust the pins to the aprox correct postion...use a mignifying glass to have a look into the

...pins on the new charger. I've stripped the laptop down and with the original charger i measure the same voltages on the quivilant pins on the motherboard. I'm confused about the voltages but the ...

...bent or broken.  Clean them with a pencil eraser so they are shiny.  Now, disconnect the charger and plug in your battery.  Do you have an indicator of power?  Will your laptop ...

charger: Replacement Toshiba Satellite L355 AC Adapter 90Watt 19V 4.74A OR 2. The DC pin on your laptop is bent/broken/loose. Look at where your power adapter plugs in on your laptop. Get a paper clip

...in the hole on the laptop. I ordered a new charger and I have the same problem. Is there a bent pin in the dc jack on the computer? Did you get the right charger? Is the DC jack on the computer

...but it leaves out two pins. None of the pins on the hard drives are bent. I just can't get them to go in. Any ideas? NO IDEAS, very sad right? put the problem in yahoo!answers too, it will be ...

cannot detect projector ok,check the pins in the signal cable connector if none of the pins is bent or not touching others....

...pins on the HDMI port are bent. Can the port be replaced? Yes, but it's probably a complete replacement of the entire motherboard of the Toshiba laptop. Very expensive -- probably as much as the ...