new 208 dodge charger with factory wig wag lights sometimes work and sometimes don't To activate factory wigwags in a 2007/2008 Police Dodge Charger, connect pin 1 of the 24way upfitter connector ...
Question about 2007 Charger SRT8 Sedan
bent in 45 degrees. What am I looking at? Its a 2007 Charger. What are the things that will be messed up with this? Estimated cost? Thanks on rear wheel drive the hub and bearing assembly is connected
bent inner tie rod. can i just replace? replace it
...where should i check to see if there is a bad connection? Pull the plug back off of the bulb and see if there is a bent pin. It's VERY easy to bend the pins if you connect it at a bad angle.
Charger and the trunk release on the key fob and the button the dash will not open the trunk. Can you tell me waht could have happened. Enter into the trunk space after folding the rear seatbacks down
...to get it out of park. Once out, the truck runs fine. Could be a bind in the shifter linkage or a bent park pin. If it is a bent park pin the transmission will have to be taken apart to
Charger (see RWD dual piston caliper below) 1 = caliper pins 2 = anchor plate 3 = caliper (dual piston with AWD) ---------------------------------------------------------------------------------------
Reprogram 2009 Dodge Charger Key Fob George.... What year/make/model does your programing solution apply to? It certainly does NOT apply to the 2009 Charger in this post. There is no circuit on pin 1 ...
...charger wont start in park it has to be in neutral its really hard to get out of park when its in reverse it says its in neutral when its in neutral it says its in drive when its in drive it goes to ...
...pins in the column that get bent and broke. Open up column, identify them and. Heck for damage. If you've also had symptoms of shifter not alligning with the selector, you can adjust a stretched ...
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions