Question about Power Products Cast Iron Bench Grinder Stand with Removable Oil Pot
...bench grinder? Goggles or safety glasses need to be worn to protect the operator's eyes from the sparks and metal filings that result. Depending on the workpiece and time of exposure, hearing ...
stop switch contact good. Once the grinder is running the probelm goes away which in turn eliminates connection problems. Capacitor faulty? if this is a cap start motor and not a centrifugal start run
...grinder. While using it I lightly tapped it on the ply top bench by mistake. It stopped cold and shows no signs of life. Opened it up and all looks normal, not much dust around switch and all. Could ...
bench grinder wont go---only buzzes hi it is an induction motor so ANY friction will stop it from starting DISSCONNECT check for any tightness when you turn it over by hand if all is well the ...
...Bench grinder. When I turn it on It just hums. It doesn't turn. Can you tell me what is wrong and which part I need to change? Thank you, Marlan PS: I have misplaced the manual. The motor has a high ...
Question about 23 684 6 Inch Bench Grinder Wheel, 60 Grit Fine
...bench grinder stopped working. When you turn on the switch it only has a quiet hum. Is it the capacitor? Try wrapping a thin cord around the shaft many times to allow the shaft to be spun in the ...
...grinder and it just stop running no power to the switch The most likely cause is the plug fuse. Open the plug and check the fuse for continuity. If there's no continuity replace the fuse. If the fuse ...
my grinder lacks power and stops as soon as i put just a little resistance to the wheels...whats wrong with it? when i turn on switch it just humms. 1/2 hp older model
Question about 6" Bench Grinder with Lamp
...bench grinder I cannot tighten the wheels once I change them. There is no stop on the arbor. It spins the same direction as the tightening nuts. Once you get them snugged a little, you will probably ...
...bench grinder is turned on it hummus but won't turn. You give it a little spin by hand and it will take off but dos'not have much power. When grinding it takes little pressure to stop from spinning. ...
Usually answered in minutes!
11 Questions
6 Questions
4 Questions