Question about U6630-900 WindTunnel Bagless Upright Vacuum
brushes are not rotating, V-belt seems too loose Hello, I realized last week, that the main brush is not rotating. I took the bottom cover off and realized that the existing v-belt seems too loose. ...
how to put on a kirby vacuum belt The emblem on the front of the Kirby vacuum controls the installation of the belt. Rotate this emblem. ( I do not remember which direction it rotates). This relieves ...
Install New Belt My old belt was destroyed so I was unable to see how it was attached. I lost my manual so instructions on how to install belt would be great. Lift the headlight and rotate the thumb ...
My brush won't rotate. i have replaced the belt once already but it melted because the only thing rotating was the motor pulley. I have cleaned all the excess hair off the brush, checked everything, ...
Question about DC14 Animal Bagless Upright Cyclonic Vacuum
Belt not broken.... brushes will not rotate. Belt not broken.... brushes will not rotate. most have two belts, brush roll rotates only when head is level with the floor....
Need to replace belt and cannot figure how to take it apart to get at the belt --- Took Screws off on the bottom but could not get to the belt You have already removed the screws so lift the brush ...
brush roller not spinning. belt, spindle okay. roller taken out and cleaned, no thread. replaced but no dice. ??? Use only BISSELL Style 10 Replacement Belts (#32074) in your BISSELL PowerForce ...
Question about 6594 PowerForce Bagless Upright Vacuum
...stopped rotating and i am unable to use my vaccum cleaner Almost certainly you have broken a drive belt. It is not a big deal though just turn it upside down and remove the base plate you should be ...
Question about 6594 PowerForce Bagless Upright Vacuum
model UH70086 agitator brush won't rotate. the belt is fine and turns the wheels. replaced v belt because I thought it was stretched but new belt is the same size. everything turns, the belts and the ...
Question about 6594 PowerForce Bagless Upright Vacuum
...belt and eventually will burn it out. The solution in the case of the brush roller is to remove it and check for free rotation. If the ends are binding, the brush roller will have to be disassembled ...
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions