Question about KSM150PS Artisan Series Stand Mixer
...beater shaft seems jammed. I can't push it up to remove my beater. best returned to service centre as these are very hard to get apart. Filled a sauce pan with hot water and placed on bowl stand. Put ...
Question about KP2671 Professional 6 Series Stand Mixer
...beater shaft. 3. Turn beater to left, hooking beater over the pin on shaft. Finally, check the groove pin on the agitator shaft to make sure it hasn?t become bent so that it doesn?t fit the beater ...
...beater shaft to hold the beater in place. There is no spring or washer on the shaft. To Attach Flat Beater,Wire Whip, or Spiral Dough Hook, simply 1. Slip flat beater on beater shaft. 2. Turn beater ...
Beater Shaft easily. Do not force the beater onto the Shaft if the shaft is bent. If it cannot be removed easily by hand, use a soft rubber mallet (not a steel hammer) to slightly tap the beater so it
Beater Shaft easily. Do not force the beater onto the Shaft if the shaft is bent. If it cannot be removed easily by hand, use a soft rubber mallet (not a steel hammer) to slightly tap the beater so it
Beater Shaft easily. Do not force the beater onto the Shaft if the shaft is bent. If it cannot be removed easily by hand, use a soft rubber mallet (not a steel hammer) to slightly tap the beater so it
...to slightly tap the edges of the beater and push the shaft out until you can see the retaining clip. Now you have enough clearance on the shaft to push the beater upward and twist it to remove
shaft of the beater is bent. After frustrating discussions with Cuisinart customer service, I was able to free my beater. First, you will notice that the beater screws onto the shaft. Unscrew it. Then
...beater The shaft of the beater is bent. After frustrating discussions with Cuisinart customer service, I was able to free my shaft. First, you will notice that the beater screws onto the shaft. ...
...shaft belt. Turn the beater bar assembly by hand to check that the unit is seated correctly. Put the base plate back on the vacuum. Align the tabs on the base plate with the slots on the vacuum and ...
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions