Questions & Answers for: Energizer battery replacement

I have a car jump starter unit that was left and went dead flat. Now it will not take a charge pluging in the charger? Unfortunately, a Jump Starting Unit which no longer takes a charge usually means ...

...were low. Thank you. Selwyn A. Colby 847 Ellynwood Drive Glen Ellyn, Illinois 60137 Try calling the battery company or taking them back to the store where you bought them. Most will have a date code ...

...Thanks for using FixYa. Kelly If the batteries are charging the battery indicators Just an FYI, but if both the RED and GREEN LEDs are flashing, there is a problem ...

...in a counter-clockwise direction to remove. Then squeeze together the two black tabs and pull the battery compartment out to replace the

Low battery light slowly blinking, normally would shut unit down on purpose and restart after a few hours of charging .......unit went dead and will not restart. CB did not pop. In the past unit would

...is no backup time when power goes . it just cuts off. can i fix this??? You need to replace the battery. HelloEither the storage battery inside your UPS or the connection to the battery may not ...

...get to them to replace. If you can remove the base, but the batteries will not slide out because of battery swelling or corrosion you can drill a small 1/8" hole in the battery base (negative end) ...

How do I replace the 2 AA batteries on the ML1W2AAE flashlight? Unscrew the base counterclock wise until it comes off. Remove the old batteries, and insert the new batteries making sure that you ...

...that the power pack has been lost from. Can this be replaced? By power pack do you mean the actual battery or the charger unit that plugs into the wall to charge or power your Palmcorder? Either